High-country-tek DVC80 Instrukcja Użytkownika Pobierz pdf (Strona 49)

P/N: 021-00154, Rev. A.6 - updated for V4.7 Tools Page | 49

Using the input fields on the right side of the

window shown you can reverse the LED’s

display side and set the Power On period for the

DVC7.

3.16 Program Variables

Program variables are identifiers that are used

by your application program to refer to specific input values and to control the operation of a specific output.

This section is divided into various subsections according to Input/Output category. The following gives the

definition of all the program variables:

LED STATE MEANING

Off No PWMs are active.

RED >> GREEN The greatest PWM % 0 -> 100%

Flashing GREEN PWM or High Side output Open circuit detected

Flashing RED PWM or High Side output Short circuit detected

LED3: Error / System Enable / Module Ready

LED STATE MEANING

On RED Unrecoverable error

On Yellow System Enable active (Power cycle required to reset)

On GREEN Module Ready

Flashing RED Low voltage (<8.5vdc) into DVC7

LED4: Error Code

LED STATE MEANING

Off No errors

On RED PWM1 Open or Short detected

On GREEN PWM2 Open or Short detected

Flashing Yellow High Side Open or Short detected

Flashing RED Application defined blink codes when blinkcode

variable > 0.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 169 170

Brak uwag

High-country-tek DVC80 Instrukcja Użytkownika Strona 49